Rivet nuts are a type of fastener that can be used in industrial, aviation and mechanical manufacturing. Because the riveting nut has good riveting effect, high working efficiency and easy to use, it is an irreplaceable nut in various fields. But many people lack understanding of riveting nuts and do not know how to properly install riveting nuts. The following, introduces the riveting nut installation precautions.
Riveted nuts are widely used fasteners in recent years. Its appearance has replaced some traditional welding processing methods in a certain range. The riveting nut is a solution to the problem of connecting some difficult-to-weld equipment with other components. The need to use riveted nuts will become very popular. What should be noted before using the riveted nut:
1. Check whether the mouth screws are properly assembled. Select the corresponding head and riveting bolt according to the size of the riveting nut, and whether the connecting parts are firm.
2. Pay attention to the deformation length or displacement of the riveted nut, and then correctly adjust the operating rod Angle.
3. The scale ring of the riveting nut is used to adjust the riveting stroke. The operation can be adjusted as required. It is worth noting that when adjusting the length of the riveting bolt, two handles should be opened to adjust the head sleeve, that is, the display length of the riveting bolt is slightly greater than the length of the riveting nut. Finally, attach the adjusting nut tightly to the body.
4. Finally, open both hands to pull out all the rubberwood, place the corresponding riveting nut on the end of the riveting bolt and tighten it to promote the rubberwood to rotate the upper bolt. Then insert the riveting nut into the pre-drilled hole of the riveted part and press down firmly on the handle. At this point, the riveting nut will rivet the workpiece, then pull out the rubber ball, and the riveting nut will withdraw from the threaded hole. A device that can complete the riveting of the nut.
Note: In the process of using manual riveting nuts. If the tie cap is loose, tighten it in time. After use, the head bolt should be protected from damage.